12-11-2008 12:00 PM - edited 03-15-2019 03:02 PM
Trying to register a new Conf bridge with CM 6.1 and it shows Registration "Rejected". Here is the GW config. Ideas?
sccp local Loopback0
sccp ccm 10.224.13.12 identifier 2
sccp ccm 10.224.13.11 identifier 1
sccp
!
sccp ccm group 1
bind interface Loopback0
associate ccm 2 priority 1
associate ccm 1 priority 2
associate profile 10 register SIN-CONF
!
dspfarm profile 10 conference
codec g711ulaw
codec g711alaw
codec g729ar8
codec g729abr8
codec g729r8
codec g729br8
maximum sessions 2
associate application SCCP
12-11-2008 12:28 PM
I'm not sure about "SIN-CONF". You might try removing the "-". Also, make sure the bridge name in CUCM matches this exactly.
Hope this helps.
Brandon
12-17-2008 06:14 PM
I experienced the same issue. Did you configure it as IOS enhanced conference bridge or just IOS conference bridge, which does matter.
also perform a shut/no shut on your profile 10
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: