12-11-2008 12:00 PM - edited 03-15-2019 03:02 PM
Trying to register a new Conf bridge with CM 6.1 and it shows Registration "Rejected". Here is the GW config. Ideas?
sccp local Loopback0
sccp ccm 10.224.13.12 identifier 2
sccp ccm 10.224.13.11 identifier 1
sccp
!
sccp ccm group 1
bind interface Loopback0
associate ccm 2 priority 1
associate ccm 1 priority 2
associate profile 10 register SIN-CONF
!
dspfarm profile 10 conference
codec g711ulaw
codec g711alaw
codec g729ar8
codec g729abr8
codec g729r8
codec g729br8
maximum sessions 2
associate application SCCP
12-11-2008 12:28 PM
I'm not sure about "SIN-CONF". You might try removing the "-". Also, make sure the bridge name in CUCM matches this exactly.
Hope this helps.
Brandon
12-17-2008 06:14 PM
I experienced the same issue. Did you configure it as IOS enhanced conference bridge or just IOS conference bridge, which does matter.
also perform a shut/no shut on your profile 10
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide