pc to access muti vlans on a 2950

Unanswered Question
Dec 11th, 2008
User Badges:

I am replacing a Cisco 2924 with with a 2950. I have a PC that is accessing vlans 55-61 on the 2924 with the command switchport muti vlan 55-61. What is the command to use on the 2950? I have tried the command :

switchport trunk allow 55-61

switchport mode trunk

on the 2950. Is this the right command to use?

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
JORGE RODRIGUEZ Sun, 12/14/2008 - 18:50
User Badges:
  • Green, 3000 points or more

It seems the multi vlan command feature is only supported on the 2900 and 3500 series switches, personally I have never had the need to used this command but from what I just read although switchport multi vlan is not the same as if you were using dot1q trunk but it resembles same effect , so you may try trunking the port and test it as long the PC NIC supports dot1q you should be good.



the port commands for dot1q encap is:



switchport mode trunk

switchport trunk encapsulation dot1q

switchport trunk allowed vlan 2,3,4,5 etc..



Regards


Actions

This Discussion