12-12-2008 10:17 AM - edited 03-13-2019 05:55 PM
Hello,
I need to install a CUBE IP_IP GW H323 to H323 on a client network that has an mpls connection to an ATT IPGW. There is no Gatekeeper involved. I need help coming up with a config to do this, I have no experience with CUBE. From what I can tell, I need to have dial-peers but the Cisco Docs just confuse me as to what I really need in the config for CUBE. I will be sending calls from CM to CUBE and CUBE will route the calls to the mpls router. Please Help!! Thx!
12-12-2008 11:14 AM
Some more details, The client is currently using a NAT router to connect calls to the provider. We wnat to replace the nat router with a cube that is setup as an H323 Gateway in CM, route calls to it and send the calls to the MPLS router out to the ATT IPGW.
Thanks,
01-06-2009 11:52 PM
are you just trying to do this to bridge the 2 different networks? I do the same thing essentailly with SIP to H323 for my home! it should be very easy, clearly defined inbound and outbound dial peers on the gateways. And enable CUBE..
voice service voip
allow-connection h323 to h323
walla! good to go!!
Cheers, please rate useful posts..
Chad
01-07-2009 08:25 AM
Hi, The CUBE is to route long distance outbound only calls from the cluster to an AT&T IP GW. H323 to H323, no SIP being used.
01-07-2009 08:26 AM
Then take out the sip commands, and take off 'session protocol sip' and change all dtmf to h245-alphanumeric.
Config still stands as good.
hth,
nick
01-07-2009 08:19 AM
The basic CUBE config:
voice service voip
allow-connections h323 to h323
allow-connections h323 to sip
allow-connections sip to h323
allow-connections sip to sip
dial-peer voice 1 voip
destination-pattern .T
session protocol sip
session target ipv4:
incoming called-number (range of your internal DID)
codec g711ulaw
no vad
dtmf-relay rtp-nte
dial-peer voice 1 voip
answer-address (range of your internal DID)
dtmf h245-alpha
codec g711ulaw
no vad
destination-pattern (range of your DID)
session target ipv4:
hth,
nick
01-07-2009 08:28 AM
Hi, I'm doing H323 to H323, no SIP involved, I hope to be able to start testing with this next week. I know there is more needed, interfaces need to be configured and binded and that is not clear to me.
Thanks,
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: