Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
391
Views
0
Helpful
2
Replies

ISIS over Frame Relay, Router 1750

sergeimavashev
Level 1
Level 1

‎12-14-2008 11:20 AM - edited ‎03-04-2019 12:42 AM

A quick question, I'm trying to run IS-IS over frame relay studying for my CCNP on a Cisco 1750 Ver 12.1,

The "Router isis" command doesn't put me in the router config mode, does it mean that ISIS is not supported on this router ?

Labels:
0 Helpful
2 Replies 2

pkoritsas
Level 1
Level 1

‎12-15-2008 07:33 PM

Hi,

I ran in to a similar problem myself in my studies a few weeks ago. You can tab the is-is commands but when you hit enter nothing happens.

You need a later IOS (12.3 I think)

Check out http://tools.cisco.com/ITDIT/ISTMAIN/servlet/index (search by product) to find out which release is most appropriate.

I hope that helps!

Phil

0 Helpful

sergeimavashev
Level 1
Level 1
In response to pkoritsas

‎12-16-2008 08:48 AM

I quick question, do you have to pay to download the latest IOS ? Because I find it, but can't download it.

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card