Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
246
Views
0
Helpful
1
Replies

route about multilink

Go to solution
martin_lx1980
Level 1
Level 1

‎12-15-2008 01:30 AM - edited ‎03-06-2019 02:58 AM

In my router there are many multilink interfaces used to connect remote offices.

I configure each multilink interface with 30-bit subnet mask.When using the command "show ip route", there are not only

C x.x.x.0/30 is directly connected, MultilinkXX

but also

C x.x.x.2/32 is directly connected, MultilinkXX

in the list.

Why the connected route with 32-bit network is in the list?

Labels:
0 Helpful
1 Accepted Solution

Accepted Solutions

Go to solution
royalblues
Level 10
Level 10

‎12-15-2008 01:39 AM

When you use PPP encapsulation, IOS by default would install a /32 route in the RT

To remove this route use the command under the interface

no peer neighbor-route

http://www.cisco.com/en/US/docs/ios/12_0/dial/configuration/guide/dcppp.html#wp4246

HTH

Narayan

View solution in original post

0 Helpful
1 Reply 1

Go to solution
royalblues
Level 10
Level 10

‎12-15-2008 01:39 AM

When you use PPP encapsulation, IOS by default would install a /32 route in the RT

To remove this route use the command under the interface

no peer neighbor-route

http://www.cisco.com/en/US/docs/ios/12_0/dial/configuration/guide/dcppp.html#wp4246

HTH

Narayan

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card