cannot issue ip policy route-map to an interface

Answered Question
Dec 16th, 2008

Hi There

I am currenlty trying to apply a basic route map to an interface on a 3750. I set the sdm prefer routing command and rebooted the switch.I now have number of IPv4 policy based routing aces: 512 in the #sh sdm but I still dont have access to the command #ip policy would anyone have any suggestions

I have this problem too.
0 votes
Correct Answer by ohassairi about 7 years 12 months ago

your interface must be a L3 one(using no switchport command).

is it a L3 interface?

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Correct Answer
ohassairi Tue, 12/16/2008 - 01:24

your interface must be a L3 one(using no switchport command).

is it a L3 interface?

bruce-hunter Tue, 12/16/2008 - 06:11

Of course thank you. Its actually an L2 port channel in trunk mode. Back to the drawing board I think

Actions

This Discussion