12-16-2008 01:04 AM - edited 03-06-2019 02:59 AM
Hi There
I am currenlty trying to apply a basic route map to an interface on a 3750. I set the sdm prefer routing command and rebooted the switch.I now have number of IPv4 policy based routing aces: 512 in the #sh sdm but I still dont have access to the command #ip policy would anyone have any suggestions
Solved! Go to Solution.
12-16-2008 01:24 AM
your interface must be a L3 one(using no switchport command).
is it a L3 interface?
12-16-2008 01:24 AM
your interface must be a L3 one(using no switchport command).
is it a L3 interface?
12-16-2008 06:11 AM
Of course thank you. Its actually an L2 port channel in trunk mode. Back to the drawing board I think
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: