12-16-2008 04:44 AM - edited 03-17-2019 09:35 PM
hi,
We have deployed cisco 2811 router in our network and had installed vic2-2fxs card in one of the HWIC slot.We need to configure fxs card for voip to make a call to branch office and have the following ios c2800nm-ipvoicek9-mz.124-17.bin .The problem we are facing is the router detect vic card under show version command but when show running-config command been given it doesn't display voice-port information to configure the same.We have attached the show tech-support o/p.any suggestion welcomed.
12-16-2008 05:54 AM
Hi Bhavesh,
It Looks like you do not have any DSP resources.You will need something like a PVDM2-8 card on the motherboard to provide DSP resources to the FXS card. Without DSP resources you cannot configure the FXS :)
Hope this helps!
Rob
12-16-2008 07:37 AM
You don't have any DSPs. This will prevent the card from coming up.
Check this link out, get some PVDMs:
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: