12-16-2008 12:31 PM - edited 03-15-2019 03:06 PM
We are trying to migrate a series of dumb internal intercoms from a analogue PBX to Call Manager 6.1 with a 2811 Voice Gateway using FXS cards. We have the intercom calling an internal number using the MGCP configuration, but the intercom does not drop/hang up the line and continues to call the configured number, even after the called handset has been replaced. We have tried to configure the voice-port with the 'timeouts' command but this does not work. Any ideas?
12-23-2008 09:07 AM
send the following:
show version
show run
show telephony-service
show ephone phone
12-23-2008 01:22 PM
If there is a ring generator on the intercom, you will need to be using an FXO port instead of an FXS. I have run into similar situations to this one in the past.
HTH,
Steve
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: