Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
295
Views
0
Helpful
2
Replies

Frame relay point to point config-help needed

asimkamran
Level 1
Level 1

‎12-16-2008 12:52 PM - edited ‎03-04-2019 12:43 AM

Hello all,

I need pointer to a link (I have already check cisco frame relay config documents on CCO) or document which will be able to provide info on how to configure frame relay point to point subinterfaces on R1, R2 and R3 where all three routers are connected to FR switch. Except for R1 which has two WAN links connected with FR switch, rest of the routers have only 1 WAN link.

I will be using OSPF for routing.

Thanks in advance

Labels:
0 Helpful
2 Replies 2

williamsdo
Level 3
Level 3

‎12-16-2008 03:13 PM

Hi , I read your posting and yu can configure FR point to point sub-interfaces off of your serial interface. Yu can then assigned the DLCI and other information on the link, the document link below should have all the information you need to complete the task.HTH

http://www.cisco.com/en/US/docs/ios/wan/configuration/guide/wan_cfg_frm_rly_ps6441_TSD_Products_Configuration_Guide_Chapter.html#wp1003569

0 Helpful

ohassairi
Level 5
Level 5

‎12-16-2008 10:08 PM

http://hassairi.50megs.com/#ipfr

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card