Right now I thought I had everything setup to do SSM but I can't seem to get things working right. I have two multicasts:
And whenever I subscribe to 184.108.40.206 with either of the source addresses in my include list I always get both of the multicasts routed to me. I can't seem to figure out the problem. What am I doing wrong? Here is my configuration.
no service pad
service timestamps debug uptime
service timestamps log uptime
no aaa new-model
clock timezone GMT 0
ip multicast-routing distributed
ip igmp snooping querier
no file verify auto
spanning-tree mode pvst
spanning-tree extend system-id
vlan internal allocation policy ascending
ip address 10.10.0.2 255.0.0.0
ip pim sparse-mode
ip igmp version 3
ip http server
ip pim rp-address 10.10.0.2
ip pim ssm range 3
access-list 3 permit 220.127.116.11 18.104.22.168
"show ip rpf" should still tell you that you have no RPF for this source at the moment.
Since vlan14 is for the sources, you should configure an IP address in the same range as the source (192.168.0.101) rather than 22.214.171.124/16. This should solve the issue.