cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
671
Views
0
Helpful
3
Replies

AAA tacacs appliance 4.1 issue

TECH SUPPORT
Level 1
Level 1

Hi,

I have a issue here on two of my new switches when i telnet i get username and password once logged in then i go to enable mode i again get a username and password prompt this time the password i have to give is enable password.

This is not a issue on other switches on the network pointing to the same server.I have a standard configuration for aaa on the network.

the switches are running 12.2(33)sxh3a

3 Replies 3

TECH SUPPORT
Level 1
Level 1

This is due to a bug in ACS 4.1

The workaround is to update the ACS.

Are you sure its a defect on ACS and not on the device IOS ?

CSCsu21040 : Enable authentication prompts for username/password instead of just pass

Version : 12.2(33)SXH03

Integrated in : 12.2(33.03.12)SXH, 12.2(33)SXH04

Regards,

Prem

My mistake it is the device ios that has the bug and not the ACS.

I think i was in a rush so made a mistake here.

Thanks Prem well spotted.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: