connecting to ASA5510 with GUI

Unanswered Question
Dec 17th, 2008
User Badges:

i have a asa 5510 band new i ve been trying to get configure it with HTTPS with a web browser and nothing is showing just the same page cannot be displayed ive got the ip address configure properly, i can not understand what the problem is. please someone out there help. i have got to have this box up and running by weekend. thank you

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
JORGE RODRIGUEZ Wed, 12/17/2008 - 09:03
User Badges:
  • Green, 3000 points or more

Hi Eric,

first make sure you have ip connectivity to inside interface ip of fiirewall, if pinagle from your PC go to next check bellow.

make sure your fw is allowing management access for your PC IP address or subnet.


asa(config)#http mask

for allowing a subnet access say on interface called inside

asa(config)#http inside

or by just ip source say is your PC

asa(config)#http inside

same format applies for telnet and ssh

telnet inside


also make sure http server is enabled


asa(config)#http server enable


igbinosuneric Fri, 12/19/2008 - 03:15
User Badges:


i just tried configuring the ASA with the

ip http ip add subnet inside command the ASA has an ip add of 1 while my pc has an ip of 150 of the same subnet i cant seem to be able to connect to the ASA with the web browser. am now trying to use command line. help !!!!!

JORGE RODRIGUEZ Fri, 12/19/2008 - 05:12
User Badges:
  • Green, 3000 points or more

Pls use cli to setup initial management connectivity, can you confirm you can ping the inside interface ip of fw from 150.

Use the example script I provided through cli.

let us know if still problems to help u, also if you could post the output of show version to make sure you have asdm image installed in fw.


charles.spaid Fri, 12/19/2008 - 05:35
User Badges:

Log into the ASA via telnet, ssh, or console and issue the command "show run". Copy the entire output and paste here.


This Discussion