VTC and NAT'ing

Unanswered Question
Dec 18th, 2008

I have a Tandberg VTC unit sitting on the inside of my network on a private IP address. I have my router configured to do NAT and have configured a one-to-one NAT for the VTC unit. I am having problems with both inbound and outbound calls. The call initially connects and then in a few seconds it drops. The NAT is pretty straight forward. I have contacted the vendors tech support and they say my firewall is blocking traffic. I have no firewall and no ACL's. I am puzzled why I am having such a problem… Does anyone have any ideas?

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
HMidkiff Thu, 12/18/2008 - 08:27

One other note. The NAT is configured using the "inside" should it be "outside"? See below.

ip nat inside source static x.x.x.x


ip nat outside source static x.x.x.x


This Discussion