Hi Giuseppe,

Thanks for the quick reply. What I am trying to do is redistribute the learned RIP address to my internal EIGRP. The device is learing the RIP information just fine but it cannot redistribute it into EIGRP.

Hello Etienne,

I wonder if RIP has the concept or route-source or it is missing it.

for example an OSPF LSA has a clear route-source the OSPF RID of the router that generated it.

With RIP data structures are changed at every hop and so I think it is more appropriate to match on the ip next hop that appears as via x.x.x.x instead of looking for a route-source

The practical effect should be the same

Hope to help

Giuseppe

Hi Giuseppe,

yes, it seems to have that capability:

HK02(config-route-map)#match ip ?

address Match address of route or match packet

next-hop Match next-hop address of route

route-source Match advertising source address of route

Well it is not showing in the topology table:

HK02#sh ip eigrp topo 198.140.33.2

% IP-EIGRP (AS 65204): Route not in topology table

but it shows up when i do show ip route 198.10.33.2 from another router.

HK00#sh ip route 198.140.33.2

Routing entry for 198.140.33.2/32

Known via "eigrp 65204", distance 170, metric 5376

Tag 12, type external

Redistributing via eigrp 65204

Last update from 10.33.94.121 on GigabitEthernet0/1, 00:08:26 ago

Routing Descriptor Blocks:

* 10.33.94.121, from 10.33.94.121, 00:08:26 ago, via GigabitEthernet0/1

Route metric is 5376, traffic share count is 1

Total delay is 110 microseconds, minimum bandwidth is 1000000 Kbit

Reliability 255/255, minimum MTU 1500 bytes

Loading 1/255, Hops 1

Route tag 12

So, it is being distributed via into eigrp.

I also tried to use "next hop" to no avail either.

I do not believe that there is a problem with your route map and believe that the route is probably being redistributed. The problem is with how you are looking for it. I set up a lab to duplicate your issue. When I issue the command sh ip eigrp topo 198.140.33.2 I get the same result of route not in table. But when I add the mask to the request sh ip eigrp topo 198.140.33.2 255.255.255.255 then I see that the route is in the table.

I suggest that you retry the show ip eigrp topology command and specify the mask.

HTH

Rick

Hi rburst,

It looks like we posted at the same time. Yes, it shows up when you had the subnet.