Question about setting up a failover asa 5520

Answered Question
Dec 18th, 2008
User Badges:

Im reviewing documentation on how to set this up..


Am I correct in assuming that I only need to configure a few lines..ip address etc

on the secondary...connect it to

a switch..


than the primary will send its configuration to the secondary?





Correct Answer by Jon Marshall about 8 years 6 months ago

Richard


In short yes you are pretty much spot on. You need to add failover configuration lines which includes IP addressing and then the active firewall will copy the entire running config to the standby -


http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_configuration_example09186a00807dac5f.shtml


Jon

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Correct Answer
Jon Marshall Thu, 12/18/2008 - 11:43
User Badges:
  • Super Blue, 32500 points or more
  • Hall of Fame,

    Founding Member

  • Cisco Designated VIP,

    2017 LAN, WAN

Richard


In short yes you are pretty much spot on. You need to add failover configuration lines which includes IP addressing and then the active firewall will copy the entire running config to the standby -


http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_configuration_example09186a00807dac5f.shtml


Jon

Actions

This Discussion