12-18-2008 11:37 AM - edited 03-11-2019 07:27 AM
Im reviewing documentation on how to set this up..
Am I correct in assuming that I only need to configure a few lines..ip address etc
on the secondary...connect it to
a switch..
than the primary will send its configuration to the secondary?
Solved! Go to Solution.
12-18-2008 11:43 AM
Richard
In short yes you are pretty much spot on. You need to add failover configuration lines which includes IP addressing and then the active firewall will copy the entire running config to the standby -
Jon
12-18-2008 11:43 AM
Richard
In short yes you are pretty much spot on. You need to add failover configuration lines which includes IP addressing and then the active firewall will copy the entire running config to the standby -
Jon
12-18-2008 12:09 PM
thx!
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: