terminal server/reverse telnet server disconnect

Unanswered Question
Dec 19th, 2008
User Badges:

I have a reverse telnet server (2620 with a async card and the octal cable)

I can terminal in fine but I can't get it to "kill" my session when I exit. I then have to go out and do a show line and <clear line tty 2033> This is irratiting me!!I seem to recall using a terminal server that would automatically log you out, return you to the terminal server. Any suggestions?

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 4 (1 ratings)
Edison Ortiz Fri, 12/19/2008 - 09:07
User Badges:
  • Super Bronze, 10000 points or more
  • Hall of Fame,

    Founding Member

It should log out all active sessions "if" you type exit on the terminal server session.

User Access Verification



Trying R1 (, 2001)... Open



(You have open connections) [confirm]

Closing: r1 !


Are you returning to the terminal server with CTRL+SHIFT+6?



Richard Burts Fri, 12/19/2008 - 09:12
User Badges:
  • Super Silver, 17500 points or more
  • Hall of Fame,

    Founding Member

  • Cisco Designated VIP,

    2017 LAN, WAN


In addition to the suggestion from Edison to use exit, I typically use shift/CTRL/6 x to get back to the term server and then type disconnect to terminate the session to the remote.




This Discussion