Solved: Card VIC 4FXS/DID and 8FXS/DID

p.maillot · ‎12-20-2008

Hello,

I have installed one card VIC 4FXS/DID and one card 8FXS/DID on my Call Manager Express.

Card 4FXS/DID on port HWIC 1 and card 8FXS/DID on slot 4, how put and extension number to port 0/1/0 for exemple?

I want to put extension "110" to the port 0/1/0

Regards

david-lima · ‎12-21-2008

H, verify that you have these commans in your router:

router(config)#voice rtp send-recv

in your active fastethernet

router(config-if)#h323-gateway voip bind srcaddr "the IP of your active fastethernet"

Hope this help

David

View solution in original post

Nicholas Matthews · ‎12-21-2008

If you have this, your configuration is correct. You have something else going on, which is very hard to speculate what it could be.

Some things to check:

No corlists configured

'show dial-peer voice summary' - make sure there aren't duplicate DNs or somewhere else it's getting dialed to.

'debug voip dialpeer' see which dialpeer is getting hit when you dial 110.

'show voice port summ' - make sure the port is up/up/on-hook

Check for number expansion that may be changing the numbers

Check any time-based call blocking under telephony service

hth,

nick

View solution in original post

Nicholas Matthews · ‎12-20-2008

These will be pots dial peers.

dial-peer voice 555

destination-pattern 110

port 0/1/0

hth,

nick

p.maillot · ‎12-20-2008

Thanks,

I have already this

dial-peer voice 1 pots

destination-pattern 110

port 0/1/0

Analog phone 110 can call ip phone 100 but the ip phone 100 cannot call the analog phone 110.

david-lima · ‎12-21-2008

H, verify that you have these commans in your router:

router(config)#voice rtp send-recv

in your active fastethernet

router(config-if)#h323-gateway voip bind srcaddr "the IP of your active fastethernet"

Hope this help

David

Nicholas Matthews · ‎12-21-2008

If you have this, your configuration is correct. You have something else going on, which is very hard to speculate what it could be.

Some things to check:

No corlists configured

'show dial-peer voice summary' - make sure there aren't duplicate DNs or somewhere else it's getting dialed to.

'debug voip dialpeer' see which dialpeer is getting hit when you dial 110.

'show voice port summ' - make sure the port is up/up/on-hook

Check for number expansion that may be changing the numbers

Check any time-based call blocking under telephony service

hth,

nick