12-20-2008 12:01 AM - edited 03-15-2019 03:10 PM
Hello,
I have installed one card VIC 4FXS/DID and one card 8FXS/DID on my Call Manager Express.
Card 4FXS/DID on port HWIC 1 and card 8FXS/DID on slot 4, how put and extension number to port 0/1/0 for exemple?
I want to put extension "110" to the port 0/1/0
Regards
Solved! Go to Solution.
12-21-2008 06:48 AM
H, verify that you have these commans in your router:
router(config)#voice rtp send-recv
in your active fastethernet
router(config-if)#h323-gateway voip bind srcaddr "the IP of your active fastethernet"
Hope this help
David
12-21-2008 12:55 PM
If you have this, your configuration is correct. You have something else going on, which is very hard to speculate what it could be.
Some things to check:
No corlists configured
'show dial-peer voice summary' - make sure there aren't duplicate DNs or somewhere else it's getting dialed to.
'debug voip dialpeer' see which dialpeer is getting hit when you dial 110.
'show voice port summ' - make sure the port is up/up/on-hook
Check for number expansion that may be changing the numbers
Check any time-based call blocking under telephony service
hth,
nick
12-20-2008 05:29 AM
These will be pots dial peers.
dial-peer voice 555
destination-pattern 110
port 0/1/0
hth,
nick
12-20-2008 07:31 AM
Thanks,
I have already this
dial-peer voice 1 pots
destination-pattern 110
port 0/1/0
Analog phone 110 can call ip phone 100 but the ip phone 100 cannot call the analog phone 110.
12-21-2008 06:48 AM
H, verify that you have these commans in your router:
router(config)#voice rtp send-recv
in your active fastethernet
router(config-if)#h323-gateway voip bind srcaddr "the IP of your active fastethernet"
Hope this help
David
12-21-2008 12:55 PM
If you have this, your configuration is correct. You have something else going on, which is very hard to speculate what it could be.
Some things to check:
No corlists configured
'show dial-peer voice summary' - make sure there aren't duplicate DNs or somewhere else it's getting dialed to.
'debug voip dialpeer' see which dialpeer is getting hit when you dial 110.
'show voice port summ' - make sure the port is up/up/on-hook
Check for number expansion that may be changing the numbers
Check any time-based call blocking under telephony service
hth,
nick
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide