12-20-2008 12:01 AM - edited 03-15-2019 03:10 PM
Hello,
I have installed one card VIC 4FXS/DID and one card 8FXS/DID on my Call Manager Express.
Card 4FXS/DID on port HWIC 1 and card 8FXS/DID on slot 4, how put and extension number to port 0/1/0 for exemple?
I want to put extension "110" to the port 0/1/0
Regards
Solved! Go to Solution.
12-21-2008 06:48 AM
H, verify that you have these commans in your router:
router(config)#voice rtp send-recv
in your active fastethernet
router(config-if)#h323-gateway voip bind srcaddr "the IP of your active fastethernet"
Hope this help
David
12-21-2008 12:55 PM
If you have this, your configuration is correct. You have something else going on, which is very hard to speculate what it could be.
Some things to check:
No corlists configured
'show dial-peer voice summary' - make sure there aren't duplicate DNs or somewhere else it's getting dialed to.
'debug voip dialpeer' see which dialpeer is getting hit when you dial 110.
'show voice port summ' - make sure the port is up/up/on-hook
Check for number expansion that may be changing the numbers
Check any time-based call blocking under telephony service
hth,
nick
12-20-2008 05:29 AM
These will be pots dial peers.
dial-peer voice 555
destination-pattern 110
port 0/1/0
hth,
nick
12-20-2008 07:31 AM
Thanks,
I have already this
dial-peer voice 1 pots
destination-pattern 110
port 0/1/0
Analog phone 110 can call ip phone 100 but the ip phone 100 cannot call the analog phone 110.
12-21-2008 06:48 AM
H, verify that you have these commans in your router:
router(config)#voice rtp send-recv
in your active fastethernet
router(config-if)#h323-gateway voip bind srcaddr "the IP of your active fastethernet"
Hope this help
David
12-21-2008 12:55 PM
If you have this, your configuration is correct. You have something else going on, which is very hard to speculate what it could be.
Some things to check:
No corlists configured
'show dial-peer voice summary' - make sure there aren't duplicate DNs or somewhere else it's getting dialed to.
'debug voip dialpeer' see which dialpeer is getting hit when you dial 110.
'show voice port summ' - make sure the port is up/up/on-hook
Check for number expansion that may be changing the numbers
Check any time-based call blocking under telephony service
hth,
nick
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: