Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
707
Views
0
Helpful
3
Replies

CME SIP Trunk sent ringback tone to caller

Gerald Chong
Level 1
Level 1

‎12-21-2008 03:52 AM - edited ‎03-15-2019 03:11 PM

Does it possible to send custom ringback tone to caller for incoming call via SIP trunk to CME ? Similar to ATA186 SIP "ConnectMode" bit19 feature? Which means the caller will hear the CME generated ringback tone rather then the telco ringback tone?

Labels:
0 Helpful
3 Replies 3

Nicholas Matthews
Level 9
Level 9

‎12-21-2008 12:51 PM

This is a hidden dial peer command that you can try:

progress_ind alert strip 8

0 Helpful

Gerald Chong
Level 1
Level 1
In response to Nicholas Matthews

‎12-21-2008 04:34 PM

Try it out, however the incoming SIP dial-peer doesn't allow "progress_ind".

I tried on outgoing dial-peer, and seems like no effect.

Are there anything else I can try ?

0 Helpful

Nicholas Matthews
Level 9
Level 9
In response to Gerald Chong

‎12-21-2008 06:27 PM

You can try taking the 8 off the last command.

Otherwise, I don't know of any other commands that can accomplish this. This command is typically used on pots legs, so it may not work for SIP trunks.

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents