12-21-2008 09:51 PM - edited 03-06-2019 03:05 AM
Hello,
I have 4 units of Cisco 3750, 12 ports stacked switches.
I have port channel configured on the stacked switches.
SW1, Stacked 1 G1/0/1 connected to G1/0/1, SW2, Stacked 1
SW1, Stacked 1 G2/0/1 connected to G2/0/1, SW2, Stacked 1
Then, I will configure a port channel, say Po1
I knew that for x-stack etherchannel, I need to use LACP instead of PAGP.
How do I make sure that the LACP protocol was used?
Does it means that if I used " channel-group 1 mode active" command, then, the cisco 3750 will automatically using LACP?
Or, do I need to use the "channel-protocol lacp" command?
Solved! Go to Solution.
12-21-2008 09:56 PM
Hi
If u used the channel-group 1 mode active LACP will be automatically enabled for the channel.
Thanks
Mahmood
12-21-2008 09:56 PM
Hi
If u used the channel-group 1 mode active LACP will be automatically enabled for the channel.
Thanks
Mahmood
12-22-2008 04:44 AM
Hi Chris,
This link will provide you all options....
Hope This Helps....
Shaheen
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: