12-22-2008 12:51 AM - edited 03-15-2019 03:11 PM
Hello,
With this command
dial-peer voice 1 pots
destination-pattern 0
port 0/3/0
forward-digits 1
With this config all extension can take this line by dial the 0.
How to authorize only a range of extension or only a specific extension to take this line?
12-22-2008 03:28 AM
this is CME or CCM ?
12-22-2008 03:37 AM
it's CME
12-22-2008 04:00 AM
ok then you need to do COR list configuration,
for example:
you have these two phones:
ephone 1
button 1:1
cor incoming phone1
ephone 2
button 2:2
cor incoming phone2
COR config:
-----------
dial-peer cor custom
name phone1
name phone2
dial-peer cor list phone1
member phone1
dial-peer cor list phone2
member phone2
then on that dial-peer
dial-peer voice 10 pots
destination-pattern 0
forward 1
port 0/3/0
cor outgoing phone2 <-- will enable only phone2 to call this number
refer to this link for more inforamtion:
please HTH if usefull
Regards
12-25-2008 02:26 AM
Thank, now I can block the "0" for a specific extension or some extension but I want to do that.
I want by dial "0" that the extension 100 can call all number begining by 2xxxxxxx and 3xxxxxxx and I want that the extension 101 can dial only 3xxxxxxx and no 2xxxxxxx numbers.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: