Using VPN client with Lan-to-LAN tunnel

Unanswered Question
Dec 22nd, 2008

Hi collegues,

i have setup VPN tunnel between two 2801 routers with exact configuration i was provided. Problem started when i recieved requirement to allow one PC to connect to 2801 with CVPN client 5.0xxxx. Generaly, i have problem how to incorporate configuration for CVPN into existing LAN-to-LAN configuration that i cant change? I realize i have to create separate isakmp policy so i did but the rest is confusing. Separate transform-set? Separate acl? I dont know, i am not some expert on thi issue. Question is what else i need to add to configuration for this to work? I will paste existing config. Thank You!

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
srdjankatic Wed, 12/24/2008 - 02:48

Tnx:) I will try it out, but i dont have access to VPN concentrator so i must not change any line in existing LAN-to-LAN config, just need to add lines for CVPN client.


chandanake Wed, 12/24/2008 - 03:05

Hi I'm Chandana,

we have a ASA5520 using ASDM we configured a IPSEC stit-to-site VPn tunnel now it is working properly.

so we want to add another device which ip is & our another site ip also same(

so I want to using group policy nat

our side ip>

remote site ip>

but both side uses can access this as a local server

so Please help me to do this nat


This Discussion