Using VPN client with Lan-to-LAN tunnel

srdjankatic · ‎12-22-2008

Hi collegues,

i have setup VPN tunnel between two 2801 routers with exact configuration i was provided. Problem started when i recieved requirement to allow one PC to connect to 2801 with CVPN client 5.0xxxx. Generaly, i have problem how to incorporate configuration for CVPN into existing LAN-to-LAN configuration that i cant change? I realize i have to create separate isakmp policy so i did but the rest is confusing. Separate transform-set? Separate acl? I dont know, i am not some expert on thi issue. Question is what else i need to add to configuration for this to work? I will paste existing config. Thank You!

andrew.prince · ‎12-22-2008

Read the below config example - it is 100% what you need:-

http://www.cisco.com/en/US/tech/tk583/tk372/technologies_configuration_example09186a00801dddbb.shtml

HTH>

srdjankatic · ‎12-24-2008

Tnx:) I will try it out, but i dont have access to VPN concentrator so i must not change any line in existing LAN-to-LAN config, just need to add lines for CVPN client.

Srkey

chandanake · ‎12-24-2008

Hi I'm Chandana,

we have a ASA5520 using ASDM we configured a IPSEC stit-to-site VPn tunnel now it is working properly.

so we want to add another device which ip is 172.16.255.7 & our another site ip also same(172.16.255.7)

so I want to using group policy nat

our side ip 172.16.255.7--> 192.168.62.1

remote site ip 172.16.255.7--> 192.168.62.10

but both side uses can access this 172.16.255.7 as a local server

so Please help me to do this nat