12-22-2008 09:55 AM - edited 03-04-2019 12:47 AM
Hello All
Maybe a easy one but I need to ask :)
I have 2 Leased Lines on 2811.
One of them will be a backup data line.
(for example serial 0 and serial 1
Serial 1 will be a backup data line)
Where should I put backup interface command and how ?
Thx for helping
Ersin
12-22-2008 10:26 AM
Hello Ersin,
under the primary interface
see
http://www.cisco.com/en/US/tech/tk801/tk379/technologies_configuration_example09186a0080093fc4.shtml
You can tune some parameters like timers or load threshold
important: the backup interface cannot be used for other purposes it will be held down and rised when primary fails (or load is over threshold)
Hope to help
Giuseppe
12-22-2008 11:25 PM
Go to interface Serial 1 and issue the command -if)# backup interface serial 0
12-23-2008 04:01 AM
Hello Rahul,
>> Serial 1 will be a backup data line
It should be the opposite
int ser 0
backup interface ser1
Hope to help
Giuseppe
12-23-2008 04:05 AM
Hello Giuseppe ,
You are right ..
Thanks for the update
Regards
Rahul
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide