WAAS and SNMP access-list

Unanswered Question
Dec 22nd, 2008
User Badges:

I am using 4.1.1c(build b16), and testing restricting access to the SNMP MIBS. we are running inline with a separate interface for mgmt. (gi1/0). with snmp access-list defined and snmp-server access-list set.


snmp-server community public

snmp-server access-list SNMP

ip access-list standard SNMP

permit 10.10.10.2


when i walk the mib from 10.10.10.2, and then look at ACL, it doesn't show any access.


CM#sh ip access-list SNMP

Standard IP access list SNMP

1 permit 10.10.10.2

(implicit deny any: 0 matches)

total invocations: 0

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
didyap Tue, 12/30/2008 - 05:46
User Badges:
  • Silver, 250 points or more

To define an IP ACL from the CLI, you can use the ip access-list global configuration command, and to apply the IP ACL to an interface on the WAAS device, you can use the ip access-group interface configuration command. To configure the use of an IP ACL for SNMP, you can use the snmp-server access-list global configuration command. To specify an IP ACL that the WAE applies to the inbound WCCP GRE encapsulated traffic that it receives, you can use the wccp access-list global configuration command.

Actions

This Discussion