GigabitEthernet0/52 is down, line protocol is down (err-disabled)

ahmed_saleh · ‎12-23-2008

I have problem with g0/52 in 3560 switch

IT_SW1_3560#show interfaces gigabitEthernet 0/52

This port has gibic

And I write show errordisble recovery the reson is Err disable reason gibic-invalid

I need to solve this problem

glen.grant · ‎12-23-2008

Cisco devices are very fussy about using non cisco gbics. If you are using a non cisco gbic then that is probably the problem . You would have to get a cisco gbic to get around this even though they can be considerably more expensive. If its a cisco gbic get it rma'd from cisco. Try doing a "shut" then no shut and see if it comes active.

ahmed_saleh · ‎12-23-2008

i have cisco gbic

ahmed_saleh · ‎12-23-2008

and i do shut no shut tell now i have the same error

glen.grant · ‎12-23-2008

Get the gbic replaced.

ahmed_saleh · ‎12-23-2008

1- i rebleaced the gbic

same error

2- this switch have 4 ports gbic and tray to change from on port is arady runing and but it in this port i have the err disable

bilousand · ‎12-23-2008

There are some old GBICs marked as cisco which do not work with newer IOS. I have had to replace some after migration from 11 to 12 IOS train.

You can try hidden IOS command in order to make them work.

Router(config)#service unsupported-transceiver

ahmed_saleh · ‎12-23-2008

ios ver 12.2