Maximum Bandwidth on ML-1000-2 POS Interface

Unanswered Question
Dec 25th, 2008
User Badges:

I have an ML-1000-2 card on Cisco 15454 ONS, I want to set up IP between two ONS with STM-4 SDH between them. I wand to map the STM-4 to the POS interface on the ML-1000-2 card. Will this POS take the STM-4? If yes, what is the maximum STM bandwidth I can map to the POS interface on the ML-1000-2?

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
viyuan700 Thu, 12/25/2008 - 10:18
User Badges:
  • Silver, 250 points or more

I wand to map the STM-4 to the POS interface on the ML-1000-2 card. Will this POS take the STM-4.


Yes you can map STM-4. But u can use only if u have XC-10G cross-connect card


If yes, what is the maximum STM bandwidth I can map to the POS interface on the ML-1000-2


You can map both port to a STM 16 rate. Each port to STM 8bandwidth.


info from cisco


The new Cisco IOS-based ML-1000-2 card is used for Gigabit Ethernet (1000

Mb/s) when the XC-10G cross-connect card is in use. It supports Layer 2 and

Layer 3 services and provides up to 2.4 Gbps of transport bandwidth, software

provisionable in transport bandwidths from 50Mbps to the ports full line rate, in

STS1, STS3c, STS6c, STS9c, STS12c and STS24c.



Actions

This Discussion