WLC failover

Answered Question
Dec 25th, 2008
User Badges:

hay


I have two WLC 4000 configured as failover.


does the configuration synchronize between the two WLCs?

Correct Answer by Scott Fella about 8 years 5 months ago

No it doesn't sync configuration.... you need to configure each wlc and make sure that both are in the same mobility group in order for the ap's to know of both wlc's.


You would need to configure the access points with a primary, secondary or tertiary wlc, in order for that ap to know which wlc it should be joined with.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Correct Answer
Scott Fella Fri, 12/26/2008 - 07:18
User Badges:
  • Super Silver, 17500 points or more
  • Hall of Fame,

    The Hall of Fame designation is a lifetime achievement award based on significant overall achievements in the community. 

  • Cisco Designated VIP,

    2017 Wireless

No it doesn't sync configuration.... you need to configure each wlc and make sure that both are in the same mobility group in order for the ap's to know of both wlc's.


You would need to configure the access points with a primary, secondary or tertiary wlc, in order for that ap to know which wlc it should be joined with.

Scott Fella Fri, 12/26/2008 - 12:23
User Badges:
  • Super Silver, 17500 points or more
  • Hall of Fame,

    The Hall of Fame designation is a lifetime achievement award based on significant overall achievements in the community. 

  • Cisco Designated VIP,

    2017 Wireless

It is also not a transperant failover since ap's will have to join the secondary or tertiary wlc.

Actions

This Discussion

 

 

Trending Topics - Security & Network