How to identify Cisco 2611XM Router

Unanswered Question
Dec 25th, 2008

Hi All,

I bought a Cisco router which I belived to be a 2611XM router. Could someone tell me how to figure it out if this router is a 2611XM or not from the output of the "show ver" command?

What do I look out for in the show version command that would tell me that this router is a 2611XM?

Thank you.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
glen.grant Thu, 12/25/2008 - 16:50

Should say right in the show version that it is a 2611xm , if only says 2611 then its not a XM .

ajagadee Thu, 12/25/2008 - 21:17

Hi,

Below is the "show version" output from a 2611xm. I hope it helps.

2600#sh ver

Cisco Internetwork Operating System Software

IOS (tm) C2600 Software (C2600-IS-M), Version 12.2(40), RELEASE SOFTWARE (fc1)

Copyright (c) 1986-2006 by cisco Systems, Inc.

Compiled Thu 12-Oct-06 21:01 by pwade

Image text-base: 0x8000808C, data-base: 0x8111D524

ROM: System Bootstrap, Version 12.2(7r) [cmong 7r], RELEASE SOFTWARE (fc1)

chi-2600-8 uptime is 22 weeks, 1 day, 12 hours, 50 minutes

System returned to ROM by reload

System image file is "flash:c2600-is-mz.122-40.bin"

cisco 2611XM (MPC860P) processor (revision 0x100) with 93184K/5120K bytes of mem

ory.

M860 processor: part number 5, mask 2

Bridging software.

X.25 software, Version 3.0.0.

2 FastEthernet/IEEE 802.3 interface(s)

2 Low-speed serial(sync/async) network interface(s)

32K bytes of non-volatile configuration memory.

49152K bytes of processor board System flash (Read/Write)

Regards,

Arul

Actions

This Discussion