SR520 basic configuration help

Unanswered Question
Dec 26th, 2008

I'm using the Cisco Configuration Assistant for the basic configuration of this router after power up. But the software says I'm not connected.

After the powerup the router's FE0 port (1st port or any other) that I'm connected to lights up and flashes and then goes solid for a few seconds, then OFF?? Is their something you have to do to this router to get it to keep it's ports on? Any Ideas?

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.

Actions

This Discussion