Time ring IP Phone

Unanswered Question
Dec 27th, 2008


When I call an IP Phone the phone ring only four times. How to increase the number of ring before the hungup?

I have try the command timeouts ring 60 without found a solution.


I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
rob.huffman Sat, 12/27/2008 - 07:11

Hi Pascal,

This may be where your current 4 ring setting is coming from (you probably have this set as 10-12 seconds). Have a look;

call-forward noan

To configure call forwarding so that incoming calls to an extension (ephone-dn) that does not answer are forwarded to another number, use the call-forward noan command in ephone-dn or ephone-dn-template configuration mode. To disable call forwarding, use the no form of this command.

call-forward noan target-number timeout seconds

timeout seconds - Sets the duration that a call can ring with no answer before the call is forwarded to the target number. Range is from 3 to 60000. There is no default value.

From this good CME doc;


Hope this helps!



This Discussion