Check status on VWIC card

Answered Question
Dec 29th, 2008

I have a WAN setup with T1's between four remote sites. I use a combination of WIC-1DSU-T1 and VWIC-2MFT-T1 cards for the links. If I have a problem with the WIC cards I enter the command 'sh service-module' and it brings up a small block of text showing errors, line up time, etc.

Now I have a T1 down that is using a VWIC card and the 'sh service-module' doesn't work on it. When I try it tells me there is no service module on the hardware. Is there a way to see the same type of info for the VWIC card as I can see for the WIC card with the 'sh service-module' command?

I have this problem too.
0 votes
Correct Answer by Collin Clark about 7 years 11 months ago

Will show controllers t1 work? It's a good command for troubleshooting T1's.

Hope that helps.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Correct Answer
Collin Clark Mon, 12/29/2008 - 06:43

Will show controllers t1 work? It's a good command for troubleshooting T1's.

Hope that helps.

Actions

This Discussion