12-29-2008 06:04 AM - edited 03-04-2019 03:15 AM
I have a WAN setup with T1's between four remote sites. I use a combination of WIC-1DSU-T1 and VWIC-2MFT-T1 cards for the links. If I have a problem with the WIC cards I enter the command 'sh service-module' and it brings up a small block of text showing errors, line up time, etc.
Now I have a T1 down that is using a VWIC card and the 'sh service-module' doesn't work on it. When I try it tells me there is no service module on the hardware. Is there a way to see the same type of info for the VWIC card as I can see for the WIC card with the 'sh service-module' command?
Solved! Go to Solution.
12-29-2008 06:43 AM
Will show controllers t1 work? It's a good command for troubleshooting T1's.
Hope that helps.
12-29-2008 06:43 AM
Will show controllers t1 work? It's a good command for troubleshooting T1's.
Hope that helps.
12-29-2008 06:47 AM
That was what I was looking for, thanks.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide