SRST FXS Ports

Answered Question
Dec 29th, 2008

I am setting up a router to run SRST with 2 FXO ports for outbound dialing. How do I get the router to use both ports. Example Port 1 is used (on a call) will the next call go to port 2? Do I just need to setup matching dial peers going to each FXO port?

Thanks

I have this problem too.
0 votes
Correct Answer by Brandon Buffin about 7 years 11 months ago

Yes, use mutliple dial peers with the "preference" command such as:

dial-peer voice 1 pots

destination-pattern 9T

port 0/0/1

dial-peer voice 1 port

destination-pattern 9T

port 0/0/2

preference 1

The default preference is 0 and the lower preference takes precedence.

Hope this helps.

Brandon

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Correct Answer
Brandon Buffin Mon, 12/29/2008 - 08:13

Yes, use mutliple dial peers with the "preference" command such as:

dial-peer voice 1 pots

destination-pattern 9T

port 0/0/1

dial-peer voice 1 port

destination-pattern 9T

port 0/0/2

preference 1

The default preference is 0 and the lower preference takes precedence.

Hope this helps.

Brandon

Actions

This Discussion