cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
297
Views
0
Helpful
1
Replies

SRST FXS Ports

wbarren
Level 1
Level 1

I am setting up a router to run SRST with 2 FXO ports for outbound dialing. How do I get the router to use both ports. Example Port 1 is used (on a call) will the next call go to port 2? Do I just need to setup matching dial peers going to each FXO port?

Thanks

1 Accepted Solution

Accepted Solutions

Brandon Buffin
VIP Alumni
VIP Alumni

Yes, use mutliple dial peers with the "preference" command such as:

dial-peer voice 1 pots

destination-pattern 9T

port 0/0/1

dial-peer voice 1 port

destination-pattern 9T

port 0/0/2

preference 1

The default preference is 0 and the lower preference takes precedence.

Hope this helps.

Brandon

View solution in original post

1 Reply 1

Brandon Buffin
VIP Alumni
VIP Alumni

Yes, use mutliple dial peers with the "preference" command such as:

dial-peer voice 1 pots

destination-pattern 9T

port 0/0/1

dial-peer voice 1 port

destination-pattern 9T

port 0/0/2

preference 1

The default preference is 0 and the lower preference takes precedence.

Hope this helps.

Brandon

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: