12-30-2008 11:41 AM - edited 03-04-2019 03:16 AM
I have a 2811 router that I am trying to run a test on for a project. I have been given a NM-HDV2-2T1/E1. Can I set up frame relay on this and if so how would I do it? Here is a sample of the commands I would like to use...
On physical interface
mtu 4400
no ip address
encapsulation frame-relay IETF
ip route-cache flow
frame-relay lmi-type ansi
On sub-interface...
interface Serial0/0.476 point-to-point
description PPVC SC100
bandwidth 128
ip address 10.98.44.1 255.255.255.0
traffic-shape rate 128000 7936 7936 1000
traffic-shape adaptive 96000
frame-relay class primary
Can this be done using that module??
12-30-2008 11:54 AM
12-30-2008 11:57 AM
Yeah, I actually meant to put it on this forum but without paying attention I placed it on the LAN forum. Sorry. This post can be deleted as the answers I was looking for are on the other post.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: