12-30-2008 11:41 AM - edited 03-04-2019 03:16 AM
I have a 2811 router that I am trying to run a test on for a project. I have been given a NM-HDV2-2T1/E1. Can I set up frame relay on this and if so how would I do it? Here is a sample of the commands I would like to use...
On physical interface
mtu 4400
no ip address
encapsulation frame-relay IETF
ip route-cache flow
frame-relay lmi-type ansi
On sub-interface...
interface Serial0/0.476 point-to-point
description PPVC SC100
bandwidth 128
ip address 10.98.44.1 255.255.255.0
traffic-shape rate 128000 7936 7936 1000
traffic-shape adaptive 96000
frame-relay class primary
Can this be done using that module??
12-30-2008 11:54 AM
12-30-2008 11:57 AM
Yeah, I actually meant to put it on this forum but without paying attention I placed it on the LAN forum. Sorry. This post can be deleted as the answers I was looking for are on the other post.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide