LMS 2.6 Pulling Router Config

Unanswered Question
Dec 30th, 2008

In LMS 2.6 how can I pull the config from a Cisco Router? I know only the Read SNMP String. Thanks for any help!

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Joe Clarke Tue, 12/30/2008 - 18:02

If all you have is the SNMP read-only community string, you cannot get the configuration. You must have one of either the SNMP read-write community string, or the ability to login via telnet or SSH, and get enabled.

If you configure those credentials under Common Services > Device and Credentials > Device Management, then RME will be able to download and archive the configuration from the router.


This Discussion