Cisco 2620xm router and Multiple (DynDNS.com) host records....

Unanswered Question
Dec 31st, 2008
User Badges:

I have a Cisco 2620xm router connected to DSL Modem (waiting for WIC-1ADSL card)......configured for DynDNS.


DynDNS is configured with the following:


mydomainname.net

exchsvr.mydomainname.net

ftp.mydomainname.net

ftp1.mydomainname.net

ns1.mydomainname.net

stinger.mydomainname.net

ts1.mydomainname.net

www1.mydomainname.net


My Cisco config file is:


ip ddns update method sdm_ddns2


HTTP

add »[email protected]/···e=&myip=

remove »[email protected]/···e=&myip=


interval maximum 28 0 0 0

interval minimum 28 0 0 0


interface Dialer1

description $FW_OUTSIDE$


ip ddns update sdm_ddns2 host members.dyndns.org

ip ddns update hostname exchsvr.mydomainname.net


A SINGLE Host record IP address WILL update just fine at DynDNS......If I enter any other SINGLE host the IP address WILL update just fine at DynDNS....


- So what command(s) do I need to enter, for MULTIPLE hosts so they will all update their IP address at DynDNS?


- Are my update intervals normal?


Thanks............

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
jbayuka Tue, 01/06/2009 - 07:07
User Badges:
  • Bronze, 100 points or more

Set your router to update a single record, and then use CNAME records to point all of your other hostnames at that record.

Update intervals depends on your dynamic DNS provider.

Actions

This Discussion