CISCO 2600 Router is not booting properly

Unanswered Question
Dec 31st, 2008

CISCO 2600 Router is not booting properly it going to rom monitor

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
JORGE RODRIGUEZ Thu, 01/01/2009 - 14:17

Go over these two links, could be number of reasons, perhaps corrupted image etc..

Go over check list on this link first

http://www.cisco.com/en/US/products/hw/routers/ps259/products_tech_note09186a0080094a0b.shtml

on same link above if currupted image you may need to push a new image via xmodem.

http://www.cisco.com/en/US/products/hw/routers/ps259/products_tech_note09186a008015bfac.shtml

Regards

Actions

This Discussion