cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
397
Views
0
Helpful
2
Replies

Cisco 2851 revert back to pervious setting after changes

Naing280184
Level 1
Level 1

It just changed back from a period of time suddenly. Initially I think I did not save it but looks like it's not the case as after I reload the module, it shown the changes I made, but for a period of time, it just revert back the change I made suddenly. As I do not make changes on the configure of the module very often (just sometimes add or remove mailbox or reset of password), so the configure I made is obvious if it gets revert back.

2 Replies 2

letsgomets
Level 1
Level 1

Make sure your config register is set properly.

I already check my register value and it's correct. But i'm using Cisco Unity Express to configure this router.

Review Cisco Networking products for a $25 gift card