How to change the connection timeout value on a HWIC-3G-CDMA interface??

Unanswered Question
Jan 2nd, 2009

How do you change the timeout value on the HWIC-3G-CDMA interface card? The connection times out or disconnects after a minute or two when there is no traffic or activity going on. Is there a way to change the timeout value so it stays connected longer?

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
didyap Thu, 01/08/2009 - 14:36

The 3G wireless HWIC provides the software functionality Automatic teardown, After a configurable timeout value, the 3G wireless HWIC automatically tears down a connection if there has been no activity.

jeremy.irvine Wed, 06/15/2011 - 06:14

'dialer idle-timeout ###' should keep the connection open until the specified time.


This Discussion



Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode