Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
257
Views
0
Helpful
3
Replies

ISP/VPN Failover Configure works but not Load Sharing

Anand Narayana
Level 6
Level 6

‎01-05-2009 02:45 AM - edited ‎03-04-2019 03:19 AM

Hi,

I have configure ISP/VPN failover & it works perfectly when ever my primary ISP fails. But I am not able to utilize my 2nd ISP when I do a static NAT when the Primary ISP is up. How can I make use of utilizing both the ISP's when I configure for ISP/VPN failover configuration?

Labels:
0 Helpful
3 Replies 3

Giuseppe Larosa
Hall of Fame
Hall of Fame

‎01-05-2009 02:59 AM

Hello Ananda,

look at the load balancing section

http://www.cisco.com/en/US/tech/tk648/tk361/technologies_white_paper09186a0080091c8a.shtml#wp30811

Hope to help

Giuseppe

0 Helpful

Anand Narayana
Level 6
Level 6
In response to Giuseppe Larosa

‎01-05-2009 03:05 AM

Thanks for the reply, but how do I achieve this on my Cisco ASA?

0 Helpful

Giuseppe Larosa
Hall of Fame
Hall of Fame
In response to Anand Narayana

‎01-05-2009 04:02 AM

Hello Ananda,

NAT with DNS doctoring could help see

http://www.cisco.com/en/US/products/ps6120/products_configuration_example09186a00807968c8.shtml

Hope to help

Giuseppe

0 Helpful
Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card