cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
404
Views
0
Helpful
1
Replies

CMM with 6 port E1 how to configure trunk groups

jeroenhermans
Level 5
Level 5

Posted in wrong section. I opened a new post in IP-telephony.

Hi,

We have a cisco WS-SVC-CMM running IOS wscmm-i6s-mz.123-8.XY7.bin and 1 6 port E1 module inserted.

I'm trying to setup a trunk group that I want to assign to 2 E1's but the system does not accept the command

trunk group. Is this not supported by the module or is it an issue with my IOS version?

Thanks for your help,

Jeroen

1 Reply 1

bwilmoth
Level 5
Level 5

Cisco CallManager assumes all loop-start trunks lack positive disconnect supervision. We recommend that you configure trunks that have positive disconnect supervision with ground start signaling.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: