01-05-2009 12:30 PM
Hello,
I am trying to configure the L2L vpn.
The cmd "crypto map MAP 10 ipsec-isakmp"
is not finishing to enable L2L vpn instead gives error:incomplete command.
if we do ? then it shows "dynamic" then selecting the dynamic thne ? shows WORD.
Why cann't we select crypto map itself.
Thanks
01-05-2009 01:43 PM
Hi,
The above syntax is valid for IOS but not for ASA.
You need to configure the Crypto Map parameters as below
crypto map MAP 10 set transform-set <>
crypto map MAP 10 set peer <>
crypto map MAP 10 match address <>
And then apply the Crypto Map to the interface
crypto map MAP interface <>
You will also need to configure the ISAKMP policies and enable ISAKMP.
Thanks,
Naman
01-15-2009 11:22 PM
Thank u very much for your posting
swami
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: