01-05-2009 12:30 PM
Hello,
I am trying to configure the L2L vpn.
The cmd "crypto map MAP 10 ipsec-isakmp"
is not finishing to enable L2L vpn instead gives error:incomplete command.
if we do ? then it shows "dynamic" then selecting the dynamic thne ? shows WORD.
Why cann't we select crypto map itself.
Thanks
01-05-2009 01:43 PM
Hi,
The above syntax is valid for IOS but not for ASA.
You need to configure the Crypto Map parameters as below
crypto map MAP 10 set transform-set <>
crypto map MAP 10 set peer <>
crypto map MAP 10 match address <>
And then apply the Crypto Map to the interface
crypto map MAP interface <>
You will also need to configure the ISAKMP policies and enable ISAKMP.
Thanks,
Naman
01-15-2009 11:22 PM
Thank u very much for your posting
swami
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide